This document is a detail page for Community Hardware Software .
Tell Us About the Product
Vendor | Fujitsu |
Product | Primergy TX100 S2 |
Product Version | MI3W-D2779 |
| |
VMware Infrastructure | ESXi 4.0.1 |
Configuration Tested | Fujitsu Primergy TX100 S2 with 4GB DDR3 memory, 2x SATA 500GB harddrives and an add-in PCI Intel e1000 Desktop adapter. |
Integration Method | Used an HP ML110G6 to install VMware ESXi v4.1 on a 4GB A-Data USB stick. Then put that USB stick into the Fujitsu machine and booted VMWare ESXi v4.1 from there. |
| |
Submitter | novaflash |
Vendor Representative? | no |
Configuration Supported? | no |
Provider Name | |
Provider Contact | |
Provider URL | |
Support End Date | |
Known Issues | Onboard NIC was incompatible - disabled it in BIOS and installed an Intel e1000 Desktop adapter. Had to set S-ATA configuration to 'compatible' in BIOS. VMware ESXi v4.1 installation vmfs3 error - bypassed through installation on a USB stick on another PC. |
Additional Comments | Takes some work - there are basically 3 problems that have to be overcome (NIC, BIOS settings and installation failure) but after that, it works perfectly fine now. |